Posts made by Rob65

It seems like this is still the case.
Would be great if the list is sorted.

Board: Duet 2 WiFi (2WiFi), Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.4.5 (2022-11-30), Duet WiFi Server Version: 1.27

@number40fan:

YWatch the wiring for the motors.

On the Duet, the wires of the motors are A-A-B-B so two wires of the same phase next to each other.
Most motors I have seen use blue-red and green-black as pairs. If you are not sure, use an ohm meter or just short circuit two wires of the motor - if moving the motors by hand start to feel more difficult those are two wires from the same phase.

O - of course do this with the wires not connected to the electronics and the printer switched off.

So if I'm understanding it correctly and I buy the Duet Wifi board with a Paneldue I'm pretty much set to installing it

Yes - I just bought a Duet Wifi and a PanelDue with 5" LCD for a printer that I converted.
If you want to use the SD card on the LCD module, you also need a 10-pin ribbon cable.

Note that if you want to upgrade to a thermocouple or PT100 sensor in your hot-end you also need a sensor and the matching daughterboard.

Wiring and configuration is a piece of cake, I got my printer printing after a day or so.

Rob

@dc42:

the next PanelDue firmware revision.

next meaning 1.18 or later I guess - on version 1.17 the M291 command does not work.

I had an M291 P"message" S3 command in a macro and this has a disastrous effect on functionality.
As soon as I execute the macro, the status line at the top of the display shows "busy" and from that moment on I cannot access the SD1 card from the PanelDue anymore.

Any idea on a release date for a new firmware revision supporting this?

I just configured some macros to deploy and retract a probe; this requires some manual intervention on my machine so I use the M291 command - works great from the web interface.

Rob