Hello everybody i have a little problem centering the y bed centre i treid al sorts of values and the heatbed always stop at the same point when i centre bed .And how do i get the nozzle closer to the heatbed? (i know in marlin it was M851 Z0 , G28 , G1 X110 Y110 , M211 S0 , M851 Z-xxx , M500 , M211 S1,)
G-day.
Posts made by Ronaldandijk
-
Printer finished only need some help.posted in Tuning and tweaking
-
RE: Need help identifying a part.posted in Duet Hardware and wiring
@t3p3tony
And L3 is replaced with a BRL3225T1R0M from TAIYO YUDEN. -
RE: Need help identifying a part.posted in Duet Hardware and wiring
@t3p3tony I was not paying attention to the polarity of the bltouch and i shorted out the ferrite bead.
i know .......that was stupid.Hooked up the usb to check if else is working cpu is working i can still connect to the duet trough wifi .I Found the part but the amp value is 2.4 a but i think that should not be a problem . -
RE: Need help identifying a part.posted in Duet Hardware and wiring
@t3p3tony Its version 1.2 ,Thanks for the help.Now i also know where to place a fuse.
