Posts made by rstaunton

Thanks @dc42, will do!

Also, just to add I have found the remainder of the pin - the solder still present - it appears the fault occurred at the point the pin goes through the board.

@cthulhulabs Good thinking - I have checked the bed resistance and it is 4.8 Ohms,
I'm sure it's not a short on the bed because the fuse has not blown.

@Phaedrux see above for the bed resistance measurement - I'm not sure whether this has changed as I didn't measure when installing.
It's a bit hard to get a picture of the heater without disassembling the bed (see image below) but it is this heater pad on a borosilicate glass plate.

Duet board was purchased March 02, 2020 from E3D.

And to answer your question on mounting, this is mounted in a printed plastic box, so nothing it can short on - again see below image (please forgive the mess of wiring from troubleshooting!).

Hi,

I have been using a Duet 2 Wifi board for around a year but this weekend, while printing, the connector for the heated bed completely melted away from the circuit board. See Images:

The heated bed I am using is 150W, powered through the Duet on 24V.
This should mean a normal current less than 6.5V which is much lower than the max of 15-18A documented here: https://duet3d.dozuki.com/Wiki/Choosing_a_bed_heater

The plastic block of the connector is fine so I don't believe it has got excessively hot from the screw block not being tight. Additionally, the bed heater fuse is the original one that came in the board, and is not blown, so the bed has not drawn current in excess of what the board will support. I have heard of the plastic block melting if the terminal is not tightened properly, but it is the metal pin that goes from the connector to the PCB that has melted in this case, so I'm not sure how this has happened. I don't believe this is anything I have done wrong, as I have taken every precaution to prevent this, such as the wires going to the bed having ferrules crimped at the ends so there is no chance of stray strands of wire making contact inside the connector block.

I contacted E3D as I had purchased from them, but they have asked me to post here as part of their agreement with you.
I look forward to hearing your thoughts,

Many thanks,
Ross