@aidar said in Duet 2 wifi Mesh compensation:
Ian means G29 saves the height map in file on SD card. And yes, you have SD card in Duet, the / sys folder is on it. Without SD card Duet will not work, assuming its Duet2 (wifi, ethernet or maestro, doesnt matter)
Thank you all, now I understand. I will check everything when I´m at home.
/Runar
Okay, thanks I try when I get home. Stupid question though, you say "save the height map in a file on the SD card" I do not use any SD card my heightmap.csv is in folder / sys. Is there a difference?
My Firmware 2,04
When I have a large print, I see that it does not cover as well at one corner of the bed and i can´t see/feel if the lead screw is moving. But I can't be sure it's activated or not. Therefore, I asked if it is the right settings I have made or is it something wrong. If the settings are correct, then I can troubleshoot other things.
I need some help with Mesh compensation. I've read all about this, but I think I've missed something.
I get a nice mesh with original BL touch but when I print it seems that the compensation is not activated. I'm a little unsure how to make it work.
The only thing I have is the following in slicer (Cura)
G28
G29
G29 S1
My printer is creality cr-10s
Firmware 2,04
Hi, borrow the post.
I have updated to Duet2Wifi and want to connect but NPN (no) sensor. I also upgraded from 12V to 24V PSU. I have used the sensor at 12V PSU and have a 15k ohms in series and bridge with 10k ohms between signal cable and ground. With 12v I get 3V from the signal cable and of course at 24v I get 6V. When the sensor is activated then everything goes down to 0V in both cases.
To be on the safe side can I use this or do I have to solder everything again but with the right resistance? Do I then connect the signal cable to "Z probe in" and brown to + and blue to - just like the picture but withou Schottky diode ?
https://d17kynu4zpq5hy.cloudfront.net/igi/duet3d/ogA64gS3SXCmPhsQ.standard