Copy that @Nxt-1 ! Thank You! Just what I was looking for, some of the stuff feels very buried in Kiss. Cheers

Has anyone firmware retractions worked when using Kisslicer? Had it working in S3D but jumped over to Kiss and struggling a bit to get the Duet to manage the retractions in the Gcode.

Thanks everyone for the suggestions!

Will try each one and get back. Just annoying that I keep having to open the case on my printed to give it a shove. It's a Noctua 40mm fan. It has to be on 100% and then give it a flick any lower and it wont keep spinning.

My part fan seems to need a push (by hand) to get it started and I have very little control over the speed of it. Any ideas?

Cheers

Had a wire come lose mid print and i'm pretty sure I've fried the PWM fan 0 and 1.

Setting them to manual to 100% didn't do anything and swapping them to PWM fan 02 everything seem to work (meaning its not the fans themselves).

Took a picture of the chips and was wondering if this is the case (looks like they have marks on them) and what are my options?

Cheers

Found it, It's the hotend fan causing it. Cheers DC for the help. Is there a fix for this or is the fan just super electronically noise (but silent to the ear!)

Disconnected the 6 pin and the board goes dead. Like its got no power (i'm guessing the board gets its power from the heater power wires?)

It's not the standard e3d fan no, but even when they are both off the green light is on and the Web interface is indicating 1000 on the trigger. I can try disconntecting the hotend fan.

So I finally set my effector up with default setting last night suggested in the guide. The probe value is stating its 1000 (activated) all the time and it seems very insensitive (have to push hard on the nozzle to make the light go off) .

Have I done something wrong or do I need to swap input value in the code/reduce the sensitivity?

So Dimensions are as follows,

Holes are 22mm centre to centre
Spigot is 6.32mm
The screw holding it is a 3mm self tapping screw with 8mm washer on