Thanks all for your great work!
I have updated my BLV Cube with Duet3 and SBC to 3.3beta3 and everything works flawlessly. It is just incredible that the software can support individual configured systems providing first class prints.

Thanks all for your great work!
I have updated my BLV Cube with Duet3 and SBC to 3.3beta3 and everything works flawlessly. It is just incredible that the software can support individual configured systems providing first class prints.

@chrishamm I believe I found it in the manual Raspian installation instructions.

.... If you wish to use the latest unstable DSF components, you can run the following commands instead:

wget -q https://pkg.duet3d.com/duet3d.gpg
wget -q https://pkg.duet3d.com/duet3d-unstable.list
sudo mv duet3d.gpg /etc/apt/trusted.gpg.d/
sudo mv duet3d-unstable.list /etc/apt/sources.list.d/duet3d-unstable.list
sudo chown root:root /etc/apt/trusted.gpg.d/duet3d.gpg
sudo chown root:root /etc/apt/sources.list.d/duet3d-unstable.list

Please be aware that the unstable repository is meant for beta testers and that it can contain experimental code. For production use, the stable repository is strongly recommended.

In case you were using the stock package feed, make sure to remove it before you run apt-get:

sudo rm /etc/apt/sources.list.d/duet3d.list

@chrishamm That´s correct, I am using SBC in stable mode. Would you mind advising me please how to change to unstable? I was already looking for DSF but could not find this either.

I have the latest RRF 3.3beta2 with the matching DWC (actually it still shows 3.2.2).

My problem is that during printing the graphical chart and the temperature for both, hot end and bed are not reported. Paneldue is showing live data.
When the printer is idle and I manually change temperatures all works fine.
Any ideas what this issue could be related to?

everything is becoming clearer with every hour I spent. Thanks so much!

Hi guys, I am new here and just got my BLV mgn cube working with Duet3 and RRF3. Very proud of this piece of equipment!

I have a little issue with parallel fans which are used for the x/y motor cooling. They do not start itself and I need to touch them to spin, then they keep on running.

I did not find any info if the frequency is related to the power? Is there any other parameter which could give it more power?

M950 F2 C"out7" Q500 
M106 P2 C"Motor Fan" T50 H0