Cheers, much appreciated.

One for @dc42
I've recently built a large Kossel based off your Precision Kossel BoM and was wondering whether you'd be able to share the duet config that you've used on it?
The blog post ends with a TBC at the point where you go into commissioning the Duet.

I have had a mess with setting up the Duet 0.8.5 in the past on a Cherry Pi 4XL build and figured with this one I could cut out most of the head scratching this time with a base set of files. I know i'll still need to modify some of the values so no problem there.

Thanks in advance

Thanks.

Order placed and ended up getting the Duet WiFi as well.

Out of interest are there any specific marketplaces for 2nd hand 3d printer parts like the 1st gen board i'll have sitting idle ?

Cheers.

Cool, thanks.

I'll end up getting one of the newer boards at some point just figure I ought to get some usage out of the old one first.

Hiya,

Just a quick one really. Will the smart effector and touch probing all work with the old duet 0.8.5 setup ?

Fancy digging my old Cherry Pi 4XL build out of the loft and finishing setting it up.
It ended up getting 'stored' when I ran into a few issues with getting decent levelling on it and work got busy.