Just a follow up...
I applied a buck converter to the external 5V power and the wifi is working again as nothing has happened.
So I'm pleased that I asked for help as I probably would not think of getting the power from the external 5V. It was easier than I thought to fix it.
Would it be very difficult to make a batch rename of all dozuki links in the database? I mean everytime I'm searching for something and entering a thread about it there are loads of links do dozuki which of course is broken. Most of the old comments in the Duet3D Forum refer to dozuki which is quite annoying.
@jay_s_uk said in BtnCmd-DWC Plugin-Custom Layouts & Buttons - v0.10.03 28-12-21:
@stout are you sure you have 3.3.0 installed? can you show a screenshot of the general settings page?
I have full control of what I've got .-) I use two different systems, both with latest official releases.Both gives the same result as shown previous.
First I used both systems with black background but it happened more than once that I shut off the wrong system during print, therefore one white and one black. But I don't really like the white backround and would like to change to blue or whatever. Don't find any CCS in /www for it. Is it a .js-file?
M122:
= WiFi =
Network state is active
WiFi module is connected to access point
Failed messages: pending 0, notready 0, noresp 0
WiFi firmware version 1.27
WiFi MAC address 8c:aa:b5:f7:be:2f
WiFi Vcc 3.29, reset reason Power up
WiFi flash size 2097152, free heap 27016
WiFi IP address 192.168.1.27
WiFi signal strength -40dBm, mode 802.11n, reconnections 0, sleep mode modem
Clock register 00002002
Socket states: 0 0 0 0 0 0 0 0
I am using version 3.4.5 both firmware and DWC.
I finally got it to work. It was the access point and a network cable plugged in but not to 100%. The little RPJ45 tap was lost. (embarrassed)