Posts made by Texzin

I am on firmware 1.20. When a print is finished the tool just stops and don't move to home. Is there g-code that takes care of moving tool to home when a print is finished?

@iDevelo:

@Texzin:

The Folger Tech FT-5 has 2z , 2y, 1x. So if I just use the Duetwifi with out the Duex2/5 I will have to connect the Y steppers in series. Can I series the Y steppers without causing problems or should I add the Duex2/5?
Can the E1 be mapped to run second y steppers?

My config above is for a FT5 Z is on the Z port (both connectors).

Thanks

@elmoret:

Yes, you can series the Y motors. That's what's happening on the stepper driver that has two connectors.

Yes, you can also run the second Y from E1, as commented above.

Thanks

The Folger Tech FT-5 has 2z , 2y, 1x. So if I just use the Duetwifi with out the Duex2/5 I will have to connect the Y steppers in series. Can I series the Y steppers without causing problems or should I add the Duex2/5?
Can the E1 be mapped to run second y steppers?

The FT-5 has 2 y motors. What is best use the one y driver on the board or add a expansion board for second motor?