Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. The Chairman
    3. Best
    • Profile
    • Following 0
    • Followers 0
    • Topics 4
    • Posts 21
    • Best 4
    • Controversial 0
    • Groups 0

    Best posts made by The Chairman

    • RE: Error: Heater 0 fault: temperature rising too slowly

      Sry, this was too easy and I gave up before I needed to. I found this code and am running it now...

      m303 h0 s100

      posted in Tuning and tweaking
      The Chairmanundefined
      The Chairman
    • RE: z axis homing fails... it just keeps clicking

      @fcwilt Thanks for the input. I tried copying code on my phone yesterday and the forum gave me an error. A friend suggested that I run m119 in the console and it showed the z stop as being off. I looked over the wiring this morning to discover that the z probe cable was plugged into the wrong spot on the Duet. Problem solved.

      I am trying to suss out my Crealty CR Touch, but I'll start another thread on it when I'm ready for input.

      posted in Duet Hardware and wiring
      The Chairmanundefined
      The Chairman
    • RE: Error: Heater 0 fault: temperature rising too slowly

      @jrcl Again, thanks. It has finished the auto-tune and gave me this message:

      Auto tuning heater 0 completed after 3 idle and 5 tuning cycles in 998 seconds. This heater needs the following M307 command:
      M307 H0 R0.532 K0.167:0.000 D13.56 E1.35 S1.00 B0
      Edit the M307 H0 command in config.g to match this. Omit the V parameter if the heater is not powered from VIN.

      I didn't see a "V" parameter in that line of code and am not sure what VIN means in this context, in any event. I easily found the line of code in my config.g and have replaced it.

      posted in Tuning and tweaking
      The Chairmanundefined
      The Chairman
    • RE: Error: Heater 0 fault: temperature rising too slowly

      Thanks to everyone here the printer is printing... I am waiting on terminals to finish the CR Touch install and I'm pretty much ready to play with it.

      [center]5e2122e5-f2dc-4f18-bf19-642c0e22c671-image.png

      0cc5ff99-e087-41a9-b291-b5badd05b659-image.png [/center]

      posted in Tuning and tweaking
      The Chairmanundefined
      The Chairman