Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
There could be something out of square with the frame, or the printhead is tilting a bit.
If you do that G92 Z0 G30 S-1 test in a row along the bed moving towards where it gets out does it slowly increase as it goes?
@thepfeiffenator looking at the mesh, i would try some physical leveling too. Either the X is tilted or bed is physically tilted. the less compensation the better. just because it compensates doesn't mean it always should 🙂
