Topics created by twistedfab13

@twistedfab13 said in Turn off Z-probe when printing?:

Its a capacitive sensor probe. Sorry, the clicking is the relay.

No need to use a relay, see https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_NPN_output_normally_open_inductive_or_capacitive_sensor or https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_PNP_output_normally_open_inductive_or_capacitive_sensor depending on which type you have.

The temp I had it seemed to be too low. Tower at temp 205 and below fell apart. 210-220 worked the best with 220 being the cleanest.

alt text

Yah figured it out. Was doing the mesh compensation. When I looked at the mesh it was really bad and all over the place. Long story short the fan cable was too close to the probe and it was registering all the time. LOL. Quick fix and now the test print it laying down correctly.

Thanks for the help!!

That did it!! Thanks for you help.