The heater still shows active, with no error messages in the GCode Console.
Going to swap extruders and test.
Latest posts made by UltiBots
-
RE: Extruder motor stops during print…posted in General Discussion
-
Extruder motor stops during print…posted in General Discussion
Hi All -
We have a printer where the extruder motor stops after an hour or so of printing. What are some methods to troubleshoot this?
After M999 or a power cycle the extruder works again.
Thanks - Brad
-
UltiBots K250VS-BSE printing in < 20min - WOW!!!posted in My Duet controlled machine
Hi All -
Quick update… the Duet WiFi installed in minutes on our UltiBots Kossel 250 V-Slot printer. We simply copied our 0.8.5 files to /sys and powered up. FSR leveling Calibrated 6 factors using 13 points, deviation before 0.129 after 0.024. We were up and printing in < 20 minutes. WOW!!!
For more info on this DeltaBot kit visit http://www.ultibots.com/kossel-250-v-slot-bse-3d-printer-diy-kit-beta
We will post pictures and videos soon.
Happy Printing…
Brad - www.UltiBots.com
772-257-one thousand (9am - 7pm Eastern)
sales )at( UltiBots dotcom