Topics created by vijays

Good Tips. Thanks @achrn.

Yes. I need to read analog input data from sensor.
Using the analog data I want to control the heater. I presume it should be realtime, so that the heaters can quickly adjust to the sensor value.

I was not aware of daemon.g and object model properties. Good points. I will explore these possibilities.

Thanks much.

@chrishamm Interesting repos. Will explore on the possibilities of these repos. However I think it still requires some learning on Vue . It would be interesting to develop and extend DWC plugins in framework agnostic way which might interests community to develop more plugins.

@vijays said in Duet3D Board to SBC (Raspberry Pi/Pico) to Galvo drivers:

Sure. I will explore on the Duet3Expansion and with RpiBuild. I think then Duet3Expansion boards works only CAN ports.. Isn't it??

Yes, the expansion boards communicate with the main board via CAN. As the Duet firmware is already set up to send movement commands over CAN, an expansion board with suitable firmware could translate those commands to DAC inputs to drive the galvo.