Posts made by xdr0ptx

Im looking for some help with gettin my duetwifi setup with my anycubic chiron. i know there is people out there who have done this swap. Im looking at how the end stops and the dual z were setup. Also looking for the startin firmware for them because burnt both printer boards on both chirons so had a duetwifi v1.04 from years ago imma use again but need a little help with it

ty so much. ill check it out hopefully get it going good soon

I did twice, but somehow the 3rd time it fixed it. Not sure cura may of bugged out a second. Now i need to fix out how its oozing when the printer stops for the corners

Somehow it fixed itself I reloaded the profile again and its working now., Just gotta fix the oozing problem i have now

Tried with and without machine center is zero. Still didnt work
that help? Its probably wrong

@T3P3Tony:

Can you check your printer settings in Cura. It should be set to Cartesian, with 0,0 at the corner and the correct axis lengths.

Who did you get your config from?

Is there a profile for a similar printer to the tevo black widow or a bw profile i can copy over that u would suggest? So that i can see if its that or not? TY for fast reply

The duet profile was from henrik a user i know with similar setup, he helped adjust to my parts im using different.
the cura profile is one i found online not sure if its right tho.

Tbh first 3d printer, Ive rebuilt this thing from the ground up almost. Ill change the other cheap electronics after its printing with the current setup. Not sure i copied the profile right, that may or may not be the problem

Started as a tevo 2017 black widow.

After all the parts they had mostly died this is the current setup atm.

Duetwifi
E3d v6 full metal hotend
E3d volcano with eruption kit
Meanwell se-600-24 psu
New 110/220v power switch
Bl touch
The extruder, nemas, and heated bed are stock for now. That will change soon.

2017 black widow (well it used to be)
Duetwifi
e3d v6 with volcano eruption kit
stock extruder (for now)
stock nemas (for now)

I setup cura to use center of printer already, but when i start a print it automatically leaves the center and goes to the left front of the printer to start printing.
Where can i change that at? Anyone know what to check on cura to make sure its sending the right info to load into the duetwifi web interface. I use the duetwifi web interface Upload and Print to print the files with.