Posts made by Zeeflyboy

Thank you, I am now up and running

Looking forward to getting printing with it tomorrow now!

Hi guys,

I'm sure I'm missing something simple but I can't seem to figure out what.

I'm using a mac, so have connected via terminal. I have verified firmware is 1.19.2 and ascertained that the wifi module is enabled and it returns idle status.

I enter the command

M587 S”NETGEAR13” P”wifipassword”

(but obviously with my actual password) expecting it to then confirm the connection and return the IP address…. but instead I get

"Error: G-Code buffer 'serial' length overflow"

Further, when I first connect this is the return:

RepRapFirmware for Duet WiFi Version 1.19.2 dated 2017-09-01

Executing config.g…Error: G-Code buffer 'daemon' length overflow
Error: G-Code buffer 'daemon' length overflow
Error: G-Code buffer 'daemon' length overflow
Warning: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicteError: G-Code buffer 'serial' length overflow

which strikes me as slightly odd.

I have tried a few times now, got no idea what I'm doing wrong. Any guidance? Power is purely through the USB as per the instructions if that is relevant.

Cheers