Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
mmm, now it stays -1% to max 1% ??
Duet3D laser filament monitor v1 on pin xstop, disabled, allow 10% to 120%, check printing moves every 3.0mm, calibration factor 1.000, version 1, measured min -1% avg 0% max 1% over 14966.6mm
@droftarts
Forever in your debt . that indeed did the trick.
My config g must have lost the configuration for the DUEX2 (not5 by the way)
I uploaded my config with the repraptool and came to the conclusion it didn't have the duex2 in the file. then saw your post
IT's back to all working now with this fan config
cheers mate
seems i have a wiring issue. compared it with my other printers
