Thanks you C0 parameter was the problem.
Jose
Thanks you C0 parameter was the problem.
Jose
When I use this setting for an emergency button, the board locks when it is working.
Is correct it?
M950 J1 C"!^exp.heater4" ; Stop buttom pullup active low
M581 P1 T0 C0 ; Emergency stop on trigger anytime
Jose
@dc42 said in Back with opnpnp again:
@qlfecv, the M308 documentation for Linear Analog sensors was wrong. The min and max reading parameters are B and C, not L and H. So use B0 C4095.
Working fine
Ok, so I try it.
@dc42 what is the best option to add the sixth axis?
I don't like using additional hardware, but with duet2wifi I have no other solution.
When I can I will buy one " Duet 3 Main Board 6HC".
I don't understand that I'm doing wrong.
I have this configuration
M950 C"bedtemp" C"nil"
M308 S2 P"bedtemp" Y"linear-analog" A"V_Sen_H2" F1 L0 H4095
The pin is 0V I send this
echo sensors.analog[2].lastReading
0.0
Now pin 3.3v
echo sensors.analog[2].lastReading
100.0
Yes, I want shorter response.
How work M409 with M308 sensor?