Back with opnpnp again

dc42

The reading of 99.9 suggests that the analog input is at +3.3V. Have you measured the voltage on the input?

qlfecv

The value is OK, but I only want to read 99.9

dc42

The value is OK, but I only want to read 99.9

Please explain what you mean. What is the voltage on the analog input pin?

Edit: Do you mean that you want a shorter response? You can get the value from the object model, for example using M409, or refer to it in a 'echo' command.

qlfecv

Yes, I want shorter response.

How work M409 with M308 sensor?

dc42

echo sensors.analog[1].lastReading
25.9

qlfecv

Thanks @dc42,

qlfecv

@dc42 Is posible read digital value? (4095)

dc42

You could set the range in M308 to 0 to 4096 instead of 0 to 100. Then if you don't want any decimals, use the floor( ) function in the echo command to convert the reading to integer. Or you can stay with 0 to 100 and multiply by 4096.0/100 first. See https://duet3d.dozuki.com/Wiki/GCode_Meta_Commands#Section_Expressions to see what expressions you can use within the echo command (and in lots of other places).

qlfecv

Thanks again

qlfecv

I don't understand that I'm doing wrong.

I have this configuration

M950 C"bedtemp" C"nil"
M308 S2 P"bedtemp" Y"linear-analog" A"V_Sen_H2" F1 L0 H4095

The pin is 0V I send this

echo sensors.analog[2].lastReading
0.0

Now pin 3.3v

echo sensors.analog[2].lastReading
100.0

dc42

@qlfecv, the M308 documentation for Linear Analog sensors was wrong. The min and max reading parameters are B and C, not L and H. So use B0 C4095.

qlfecv

Ok, so I try it.

@dc42 what is the best option to add the sixth axis?

I don't like using additional hardware, but with duet2wifi I have no other solution.

When I can I will buy one " Duet 3 Main Board 6HC".

T3P3Tony

@qlfecv where are you based?

qlfecv

In Barcelona, Spain

T3P3Tony

@qlfecv ah cool. I think @dc42 will be in contact.

qlfecv

@dc42 said in Back with opnpnp again:

@qlfecv, the M308 documentation for Linear Analog sensors was wrong. The min and max reading parameters are B and C, not L and H. So use B0 C4095.

Working fine