Single Setup for Duet 3
-
@bearer I was logged in as pi when I executed all the dozuki instructions. Many of those use sudo. I did have to add sudo in front of one of the commands though.
-
@4lathe DSF wont serve anything is the Duet is not connected.
-
@T3P3Tony ahhhhh. What was that error? Any good way to test that the web server is running?
-
@4lathe said in Single Setup for Duet 3:
So I just setup my rpi4 in advance of receiving my duet 3 this week
Ah, as tony says, thats not gonna work. everything depends on DuetControlServer, and it won't start without the Duet3 connected.
-
@bearer ok so just leave it for now?
-
@4lathe said in Single Setup for Duet 3:
so just leave it for now?
yeah, might as well, you won't be able to verify the software anyways.
Although I'm puzzled by the fact that you say you get a HTTP 500 error if the Duet3 isn't connected, which is why I glossed over that bit initially.
-
@bearer no idea.
-
@bearer said in Single Setup for Duet 3:
@4lathe said in Single Setup for Duet 3:
so just leave it for now?
yeah, might as well, you won't be able to verify the software anyways.
Although I'm puzzled by the fact that you say you get a HTTP 500 error if the Duet3 isn't connected, which is why I glossed over that bit initially.
The DuetWebServer will start but it communicates with the DuetControlServer via that /var/run/duet.sock socket which is created by the DuetControlServer and that won't even start if it doesn't get a response from the Duet3 via the SPI bus. So when you access the web server, it responds with a 500 because it can't connect to that socket.
-
@gtj0 ah, must have changed the behavior at some point then, previously it would terminate right away if started manually without DuetControlServer; and the systemd service won't even start.
Anyways, moot point, gotta wait for the board in any case.
-
@bearer thx much for the explanation.
