Custom Splash Screen
-
Dear PanelDue enthusiasts,
I tried to add a custom splash screen to my PanelDue 7i, ER-TFTM070A1-4 V2.0 board with ATSAM4S4B chip, without success.
After following these instructions:
https://miscsolutions.wordpress.com/paneldue/
and these:
https://www.instructables.com/id/How-to-Add-a-Splash-Screen-to-PanelDue/
The logo.bin file was concatenated to the PanelDue-5.0i-7.0i-nologo.bin (release 1.23.2). The new firmware worked but no logo appeared.
The v2 firmwares don't work with my PanelDue.
What would you think am I doing wrong?
I suspected the image would be to blame, but not sure if I have the right one.
Any help would be appreciated.
-
Your image upload failed.
Did you get any errors during the process?
-
@Phaedrux no errors at any step.
Image is 800x400 px inkscape exported png, saved as 24bit bmp with MS Paint (Windows 10). Image bin is 20KB, after concatenation firmware is 150KB.
Flashed successfully everytime using the i7 file. V2 doesn't work on my screen.
I'll try to upload the file again
-
@DDD said in Custom Splash Screen:
I tried to add a custom splash screen to my PanelDue 7i, ER-TFTM070A1-4 V2.0 board with ATSAM4S4B chip, without success.
That's a contradiction. Version 2 PanelDue boards have ATSAM3S2B or ATSAM3S4B. Version 3 boards have ATSAM4S4B.
-
@dc42 that's the info on the board
-
@DDD said in Custom Splash Screen:
that's the info on the board
as in silk screen or also the marking on the cpu? does bossa agree as well?