4.3" blank after upgrade
-
HI *,
I received my PaneDue 4.3" today. My first reflex was to update the firmware, bad decision.
I followed the instruction from "https://duet3d.dozuki.com/Wiki/PanelDue_Firmware_update" and I used "https://github.com/dc42/PanelDueFirmware/releases/download/1.24/PanelDue-v2-4.3.bin" because I want to use it on a Duet 2.
The result was a blank screen. I tried "https://github.com/dc42/PanelDueFirmware/releases/download/1.24/PanelDue-v3-4.3.bin" which worked but this is the wrong version.My understanding is that I need to use "v2" because of the mainboard, right? Not because of the Firmware version.
I tried the "verify" function in "Bossa" which confirmed that the FW is fine.
Any ideas?
Cheers, Chriss
-
are you resetting the panel after the flashing? (i prefer the command line version with -R to deal with it for me)
-
@Chriss “My understanding is that I need to use "v2" because of the mainboard, right? ”
No.
-
@bearer Yes, I reseted the display after the flashing. Btw: I have the same problem with the oder firmware too. It works with v3 but not with v2. I may test the command line version tomorrow.
So if the v2/3 is indicating the firmware and not the board, should I upgrade my board to v3. The board is still on my desk, it will serve a cr10s pro v2 sooner or later, so I do not loose anything.
Cheers, chriss
-
The V2 and V3 in this context refers to the version of PanelDue you have. It has nothing to do with the Duet board at all. If this is a new unit, it's most likely a V3.
PanelDue v3.0 4.3" PanelDue-v3-4.3.bin
That's your bin file to use. Go through the flashing steps again carefully.
-
@Phaedrux Thanks.... That made it clear. My understanding was wrong. :m I guess that somebody may like to make that point clear at the documentation. The filename is a bit confusing for a newbie.
Cheers, Chriss
