BL-Touch - multiple problems -
-
sos
I think @Phaedrux lives in a different time zone and I don´t wanna stress anybody.
Can anybody else help me?
thanks -
@barbarossa-cologne said in BL-Touch - multiple problems -:
RepRapFirmware for Duet 3 MB6HC 3.01-RC9
To begin with, update your firmware to 3.1.1
Does your BLTouch respond if you send M401 and M402 to deploy and retract the pin?
Does it respond if you send it the command to enter test mode?
M280 P0 S120What version of BLTouch is this?
-
@Phaedrux
short describtion for update firmware?
with pi 4M401 / M402 are not working. The web control shows the normal green button on rigth bottom screen but no moving.
When I connect the BL the test move happens.......M280 P0 S120
- green button on screen, no moving or something else.
I don´t know which version. Can I see it on the wire colours?
Original from antlabs and bougth last week.
thanks to canada -
This post is deleted! -
@barbarossa-cologne said in BL-Touch - multiple problems -:
short describtion for update firmware?
with pi 4M401 / M402 are not working. The web control shows the normal green button on rigth bottom screen but no moving.
When I connect the BL the test move happens.......
M280 P0 S120green button on screen, no moving or something else.
It sounds like a wiring issue. The probe is getting power and ground, but no signal. Triple check your wiring and crimps. A good test is to connect the short leads from the BLtouch directly to the board to eliminate the extension wires.
-
@barbarossa-cologne
I saw this settings made in the configuration tool. I tried to change the settings manual. Maybe I made somethig wrong there?
-
That all looks ok as long as you're actually wired up to the io7 in and out pins.
-
@Phaedrux
ok. I´ll check everything- -
@Phaedrux
What do you mean with ´´actually wired up to the ioin and out pins´´? -
I mean that your config looks ok, now the wiring must be correct for the config to work.
-
@Phaedrux
ok sry.
I tested the wiring. Its not the problem....
this is the last problem I have to solve before starting. Thats really bad. -
If that's the case and the wiring is good please update your firmware (as linked above for the Duet + SBC). Send M115 after to verify.
Then please send M98 Pconfig.g and report any errors.
-
@Phaedrux
M98 Error: Non-empty string expected
firmware is updated -
That's a weird error. You're sending this exactly?
M98 Pconfig.g -
-
try M98 P"config.g"
-
@Phaedrux said in BL-Touch - multiple problems -:
M98 Pconfig.g
´´´Response to long, see console´´.
I havent connected the expansion board, yet. Is this a problem? -
Are you in the DWC gcode console when you send that?
-
@Phaedrux yes
-
I homed z again. It's homing without triggering manual the BL.
Also when I go down with the z axis... doesn't care which amount and then homing z, the z motors are turning back always the same amount and it stops.
--> I hope that helps
