Random Smart Effector flashes

[sankafola]

@dc42 its flaying extruder with 20 cm tube , the thing is if its the bed electromagnet it should affect it all the time not just random , here is my setup

[dc42]

Does the random flashing stop when you raise the effector well above the bed?

[sankafola]

@dc42 no the random can happen also while its home which is very far from the bed

[A Former User]

the light shown is that led's on/near the effector? does it help to turn lights off?

[sankafola]

these lights of the smart effector why turn off? you think its related to the random flash ?

[A Former User]

@sankafola said in Random Smart Effector flashes:

these lights of the smart effector why turn off? you think its related to the random flash ?

was just thinking if they were external leds and you're looking for a source of noise, it'd be worth looking into.

[sankafola]

its built in LED in the smart effector and i dont think its related because they are on while its working normal too its built that way

[sankafola]

@dc42 just to be sure the LED which flash random is the same LED which flashes 2 times when it turn on the printer

[sankafola]

@dc42 what do you think ? do you think the smart effector the card itself have something wrong ?

[Phaedrux]

We will authorize a warranty replacement on the Smart Effector. It's possible there is an issue with it causing it to be too sensitive. Please contact your vendor and initiate a warranty exchange. Include a link to this thread as authorization.

[sankafola]

@Phaedrux thank you will do