Bed Heating SSR
-
Je dois faire une mise a jour vers la version 3 ?
-
Ok so the problem is that your config.g is formatted for RRF3 but you have RRF2 installed. I suggest that you update your firmware.
Connect to the web interface and upload these zip file as is (do not extract them first) to the system folder.
https://github.com/Duet3D/RepRapFirmware/releases/download/3.0/Duet2and3Firmware-3.0.zip
https://github.com/Duet3D/RepRapFirmware/releases/download/3.1.1/Duet2and3Firmware-3.1.1.zip
Afterwards you should be running firmware 3.1.1 and your config.g should work a lot better. Send M115 to confirm.
Then send M98 P"config.g" and report any error messages.
-
-
Install updates?
You have uploaded at least one firmware update. Would you like to install them now? i say yes or no -
Upload them one at a time starting with 3.0 and update, reboot, and then upload 3.1.1
-
06/10/2020 à 23:58:37 M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.05.1 ELECTRONICS: Duet WiFi 1.02 or later + DueX5 FIRMWARE_DATE: 2020-02-09b1 -
M997 S0:1
Error: M997: In-application programming binary "iap4e.bin" not found -
Upload the full zip file as is. Do NOT extract it.
-
oui j'ai telecharger le fichier ZIP
-
j'ai toujours se message d'erreur M997 S0:1
Error: M997: In-application programming binary "iap4e.bin" not found -
When uploading the zip file to the /sys folder it should prompt to install the firmware. You do not need to send M997 at all.
However, because it is complaining about missing IAP files you can try this method which should also work.
-
ok i try thanks
-
not work
-
Can you make a video of your screen showing what you're trying to do?
-
yes but the link is for duet3 and i have a duet2
-
Yes of course you are correct. Sorry about that.
I think you are missing some files from the 2.05.1 release which makes me think you might be uploading the wrong zip file.
Please download these zip files fresh and make sure you don't change the names.
https://github.com/Duet3D/RepRapFirmware/releases/download/2.05.1/Duet2Firmware-2.05.1.zip
https://github.com/Duet3D/RepRapFirmware/releases/download/3.0/Duet2and3Firmware-3.0.zip
https://github.com/Duet3D/RepRapFirmware/releases/download/3.1.1/Duet2and3Firmware-3.1.1.zip
Start with 2.05.1 zip file and it should update everything for RRF2.
Then do 3.0 and then 3.1.1.
-
2.05.1 OK
3.0 OK
3.1.1 is really too long is it normal ? -
Its work but i have one again problem im so sorry Error: Heater 0 fault: temperature rising much more slowly than the expected 1.7°C/sec
-
do you know for why is like that
-
PID problem ?
