Duet2 WiFi Firmware on Raise 3d E2 ?

[Proschi3D]

@Proschi78 said in Duet2 WiFi Firmware on Raise 3d E2 ?:

RepRapFirmware for Duet 2 WiFi/Ethernet version 2.02(RTOS) running on Duet WiFi 1.02 o

[Proschi3D]

these data are on the original sd card

[Proschi3D]

@jay_s_uk do you think version 3.3 would work with the bin file you gave me?

[jay_s_uk]

@Proschi78 that bin file is 2.02 built from the raise3d sources.
If you want to install RRF 3 you first have to go to 3.0 using the zip file from here https://github.com/Duet3D/RepRapFirmware/releases/download/3.0/Duet2and3Firmware-3.0.zip

[Proschi3D]

@jay_s_uk 3.0 dont work on the printer

[Veti]

you can still go klipper with mainsail
that will give you a good alternative.

[Proschi3D]

@Veti first I want to get the board running again

[Veti]

have you tried these firmwares

https://www.raise3d.com/download/motion-controller-board-firmware-all-versions/

[jay_s_uk]

@Proschi78 the iap from here should work https://github.com/Duet3D/RepRapFirmware/releases/download/2.03/iap4e.bin

[Proschi3D]

@jay_s_uk with 2.02 ?

[jay_s_uk]

@Proschi78 yes

[Proschi3D]

@jay_s_uk ok i will test it

[Proschi3D]

@jay_s_uk

[jay_s_uk]

you need to rename it to match the missing file

[Proschi3D]

@jay_s_uk

[jay_s_uk]

have you uploaded the file i sent you to the same place?

[Proschi3D]

@jay_s_uk yes

[Veti]

@jay_s_uk said in Duet2 WiFi Firmware on Raise 3d E2 ?:

iap4e.bin

did you rename it to Duet2combinesIAP.bin like the error message says?

[Proschi3D]

[Veti]

where did you put the file on the sd card?