Any full working Ender 5 Plus configurations?

[catsandicecream]

I've been trying to edit a modified ender 5 configuration for the ender 5 plus and using the reprapfirmware configuration to generate config files. However the BLTouch settings generated by the configurator definitely needed editing afterwards. Also it defaults to homing Z with an end stop and not with the probe as well has homing x and y to 0 when it hits the endstops in the far right instead of front left as the origin.

[Phaedrux]

If you post your config and homing files we can probably get you sorted out. What firmware version are you using?

[catsandicecream]

I put my config up here -
https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

And made a tiny tester @ 0.24mm layers that has a bit of stringing with PLA, but otherwise reasonably solid. I may tweak my PrusaSlicer settings.

Tiny_Tester-e5.gcode

How can I determine what are my max speeds for my axes and are there any optimizations I forgot? I think I will also re-use the bed mesh saved to disk instead of constantly probing the bed every run. Also, when doing the top layer, the extruder skipped a bit. Not sure if that's from my slicer settings or the extruder rate in config.

[Phaedrux]

I think you've got an ok start. If you've already got it printing that's 90% of the battle.

Check this out: https://forum.duet3d.com/topic/14250/tuning-jerk-accel-speed-settings/2?_=1586651239957

[catsandicecream]

@Phaedrux said in Any full working Ender 5 Plus configurations?:

https://forum.duet3d.com/topic/14250/tuning-jerk-accel-speed-settings/2?_=1586651239957

Thanks

Additionally, has anyone tried making the existing touch screen panel work? I'm assuming it's the same touch screen in the CR-10S Pro, the model on the panel says "dmt48270c043_06wt". It seems to be a commodity panel, but I assume Creality put some sort of firmware on it for easy communication between the panel and the main board

[conorsmyth]

Hi, did you get this working in the end. I'm trying to do the same. I was also wondering if you put the second z motor into one of the extruder slots or did you somehow wire the motors together to the same driver?

Either way I'd look forward to hearing how it turned out

[leewaa]

Old topic but possibly valuable information available on this, hence a thread revival/bump.

@catsandicecream did you end up making progress on this ?

[Reine]

If someone has a working config I would be interested in having a look as I'm in the process of converting my Ender 5+.

[droomoo]

I also would be interested in a config dump as I have an Ender 5 Plus I want to convert as well.

[catsandicecream]

Sorry, I don't have notifications turned on. I'm finally upgrading to RRF 3.x, and will have an updated configuration once I have everything working again.

[catsandicecream]

I've updated my config for RRF 3.x and updated it on GitHub - https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

Will happily take any input if people have better settings.