printer movement on startup

[jay_s_uk]

whats in your tool change files for T2?

[Orang_]

@jay_s_uk said in printer movement on startup:

whats in your tool change files for T2?

????

[Orang_]

tfree2, tpost2, tpre2 - I removed them because they were not needed

[Stephen6309]

@Orang_ Change the T2 to T0 in config.g? From those differing tool Z heights, you do have a tool changer?

[Orang_]

@Stephen6309 said in printer movement on startup:

@Orang_ Change the T2 to T0 in config.g? From those differing tool Z heights, you do have a tool changer?

at t0 the same thing,

[Orang_]

@Orang_ I figured it out, it is the effect of the tool offset in Z. But how to make the printer not react when loading

[taconite]

good question I have the same effect and always wondered what it is

[Orang_]

@taconite Well, apparently, after loading the initial settings, the tool is loaded with an offset

[Stephen6309]

@Orang_ You have different heights above the bed for you nozzle. T0 will reach the bed, but T1 and T2, won't.

[Orang_]

@Stephen6309 Thank you. I know. I set the correct offset value at t0. tool t1,t2 are experimental, but still if the tool offset is set, the printer raises the Z-axis when it is turned on