Upgrading Firmware.

mendelevium

To be honest, I am still testing this printer as I have migrated from ramps.. still my extruder is not running. The extruder buttons on the web console are mot highlighted and unresponsive.

mendelevium

@droftarts thanks for this I will go through it...

Phaedrux

@fcwilt said in Upgrading Firmware.:

M563 P1 S"EXTRUDER 1" D1 H2 F0 ; define tool 1

If you have a separate fan for each tool, then your second tool should probably be using fan1. Change the F0 to F1.

@fcwilt said in Upgrading Firmware.:

G10 P0 X-16.5 Y0 Z0 ; set tool 0 axis offsets

I'm not a multi tool printer users, but I think it's usually the case that the first tool is set as a zero offset and the other tools are then offset from there. Just keeps things easier.

fcwilt

@Phaedrux

You replied to me because I reposted his config.g using the </> tag.

I don't know if he will be notified of your post or not.

Frederick

mendelevium

I will go through the tests and see. This is my first twin extruder machine I built. I had very little experience. This printer I have installed Mechaduinos on X & Y. I have soldered STEP AND DIR POINTS on the test points on the board. The mechaduinos I have set the PID settings when it ran Ramps, so I am assuming the PID`s are ok with the duet in use. I have arranged for a dedicated 5V supply to power the Vin points on the mechaduino. I have yet to test in printing...

Phaedrux

@fcwilt said in Upgrading Firmware.:

I don't know if he will be notified of your post or not.

I think as the thread creator he would get a notification on all replies. Unless he's turned that off entirely.

mendelevium

One other thing I notice is that on the dashboard- Job status says NO EXTRUDERS

Phaedrux

Screen shot of what you're seeing?

Can you also send M122 and M98 P"config.g" in the console and copy and paste the results here?

mendelevium

managed to run the extruders now. Apparently, I edited the config as per suggestion on a forum.. don not know if it was this or any other honestly since I had found it days ago and screen shot it out, But the extruders are running nicely by command..

mendelevium

many thanks all who put an imput. Its appreciated a lot. Have a nice weekend.