Paneldue says "connecting" and controls nothing

3dpnut

Re: Got my paneldue... It says "connecting" and controls nothing...

@Steve-Lynch did you ever figure out what was going wrong? I have exactly the same issue...

T3P3Tony

hi @3dpnut what version of the firmware are you running and on what Duet board. if its RRF 3.x you need to explicitly enable the PanelDue port, for example on a

M575 P1 B57600 S1 ;enable panelDue UART

https://duet3d.dozuki.com/Wiki/PanelDue#Section_Firmware_configuration

garyd9

@T3P3Tony said in Paneldue says "connecting" and controls nothing:

hi @3dpnut what version of the firmware are you running and on what Duet board. if its RRF 3.x you need to explicitly enable the PanelDue port, for example on a
M575 P1 B57600 S1 ;enable panelDue UART
https://duet3d.dozuki.com/Wiki/PanelDue#Section_Firmware_configuration

Also, make sure that the paneldue itself is using the same baud rate set in M575. Even when the paneldue isn't communicating with the duet, you can still go into the paneldue's setup page to change that.

mfs12

Closed due to inactivity. Please re-test with recent version and start a new thread if needed.