info ir probe delta

Kevin

hello

i have a question I recently got a delta printer flsun qqs pro (first delta end a very bare board)

i want to change the board after a duet wifi, but am not sure which probe for z height inc. mesh bed

ir / bltouch / original click switch (which I do not own)

bltouch v3.1 I still have lying around from the previous project.
but no experience with bltouch.

ir probe i have on a cartesian printer but cons axis tilt on the delta i read

who has tips or good advice

thanks kevin

Phaedrux

Ideally for a delta you'd want a probe that uses the nozzle as the trigger point to avoid an offset.

https://duet3d.dozuki.com/Wiki/Choosing_a_Z_probe

The smart effector is the best option for a delta, IMO.

Kevin

@phaedrux
I am now indeed looking for the smart effector together with the Haydn Huntley's Magball delta arms 288mm,

this turns out to be the best option (only tax and shipment is more expensive than the product itself :))

Gaou

@kevin said in info ir probe delta:

@phaedrux
I am now indeed looking for the smart effector together with the Haydn Huntley's Magball delta arms 288mm,

this turns out to be the best option (only tax and shipment is more expensive than the product itself :))

that's really a problem . if you are located to eu there is an alternative of 360mm long. you ll lose some mm of ur height but see this as a opportunity to upgrade ur printer to a taller one.

Kevin

@gaou

there is no other option if ordering directly in the usa also find no other sellers.

and with 360 I lose even more height, already go lower in the z height with hotend setup and 288 rods

but thanks for thinking along