I've watched it for a few weeks and haven't had any more mistakes.
replaced the cables and laid them along a different route
i followed the steps,
but after sending G30 S-1 the nozzle digs into the bed and crooked the towers and effector .
the result after the G30 S-1 =
Stopped at height -2.346 mm
(it doesn't stop at bed height but goes deeper)
it's even worse when I run a G29
I have added two movies of G30 S-1 command and G29
this is the G30 S-1 https://youtu.be/QhDlxRcwmeY
and this the G29 https://youtu.be/mDf4vhKAQFY
I found the problem
I checked everything from cables to bearings/belts, but it turned out that the lm8uu bearings of the carriages became stiff at some point and replaced them (that's why it worked on the head gravity )
but unfortunately I have another problem.
if I want to set the trigger height, it is located in the minus under the bed.
performed a few times G92 Z0 that the is Z0 but after home too high nozzle picks up paper -1.50
when I feed a G30 S-1 or G32 nozzle rams into bed
(G30 S-1 Stopped at height -2.786 mm)
in which direction should I going to search?
thanks for the response
i'm going to reconnect and double check all cables and start with a clean config tool.
there must be something wrong with my setup,
I'll let here know if I find out anything but unfortunately I can only work on it during the weekends due to lack of time
i'm still in the startup phase of the delta can still look messy the config file
these are the files you asked for
I can't figure out why it only goes home after the printer is upside down, tried with and without arms but remains the same only home z.
I have not progressed as home all and pid tuning hotend and bed
sorry for the later response but it works it finds the limit switches, but this works differently if rr2.xx led on is not trigger and led off is triggered
but i have another question now
or should i ask a new question on the frorum ?
when I do home all only the z axis goes after home (x/y axis is stationary belt rattles minimally)
when I turn the delta upside down it does go to home all with the arms and smart effector mounted.
I found out after everything connected and wanted to calibrate the smart effector it does not work as it should be .
was working upside down because everything is mounted under the printer .
I'm working on limit switches but working the other way around switch not triggerd is red light and switch triggerd is red led out
RepRapFirmware for Duet 2 WiFi/Ethernet version 3.1.1 running on Duet WiFi 1.02 or later
at version 2.0xx I could see machine properties the switch here at 3.1.1 not
M574 X2 S1 P"!xstop"
M574 Y2 S1 P"!stop"
M574 Z2 S1 P"!zstop"
Endstops - X: at max stop, Y: at max stop , Z: at max stop, Z probe: not stopped
i use the nc and c switch and gnd-xyz stop on duet its a delta printer