DUET 3 broken?

dutti

@barbarossa-cologne

dutti

@barbarossa-cologne

chrishamm

@barbarossa-cologne Yes, you cannot install a Raspberry Pi image on the Duet controller. Please use this firmware binary instead and reset the board when done.

Phaedrux

As linked in your other thread

To update the firmware on the Duet
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Fallback_procedure_Num_2

And setting up the Pi
https://duet3d.dozuki.com/Wiki/SBC_Setup_for_Duet_3

dutti

@phaedrux
I already tried all the fall back procedures.
NOW.. it´s not possible to connect via YAT or Bossa.
Etcher is not working because the flashing procedure fails...

dutti

@chrishamm
ok!! this should work at the moment. thanks!

dutti

@chrishamm

dutti

@barbarossa-cologne
connected to YAT:

no response

Phaedrux

@barbarossa-cologne said in DUET 3 broken?:

no response

Because it has no firmware.

Connect the Duet 3 via USB.
The erase jumper would be used to erase the firmware. That's already happened I think since there appears to be no firmware installed.
Remove the jumper now and the Duet should show up in the device manager as a Bossa port.
Now use Bossa to flash the Duet3 bin file using the settings outlined in the link.

https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_All_other_Duet_boards

dutti

@phaedrux
ok.... that has worked. Also verify the new software.

dutti

@phaedrux
Everything is working!!
thanks a lot

dc42

@barbarossa-cologne to clarify: flashing via Bossa fails when the Erase jumper is still in place.