HevOrt impressions?
-
Hin
as I have commented in another post, I am studying the possibilities to make a new printer ...
Until a while ago, I was hesitating between: Voron Trident and Ratrig v3 ....
But a new option enters the fray, and it is HevOrt, which uses 3 leadscrews on the Z axis, for self-leveling ...
My question is clear, this function is supported by the Duet 3 mini board, and I suppose any expansion?
Can someone who has this printer give me feedback?
Is it possible that this printer can do "non planar layers"?
The HevOrt project looks good ... I'm looking for opinions, until minutes ago I opted for the RatRig ... but ...
-
@peirof said in HevOrt impressions?:
My question is clear, this function is supported by the Duet 3 mini board, and I suppose any expansion?
Bed levelling with independent Z motors is supported but the Duet 3 mini (and all Duets running up to date enough RRF). You get 2 extra drivers on the mini 5 by using the mini 2+, with 3 Z, 1X and 1Y you have an extruder and a spare.
-
Love my HevORT HD12. Runs duet 3.
-
@sji where you buy parts needed?
-
Some from Aliexpress, some locally. Mellows store is good for quite a few items needed
-
@peirof said in HevOrt impressions?:
Is it possible that this printer can do "non planar layers"?
...learn to walk, before you run they say
There is no common slicer for non-planar layers yet.
If you like, you can also re-design the RatRig with short linear-rails under the bed for non-planar-boogie
