sensor ir

[A Former User]

@jumpedwithbothfeet yes look

[A Former User]

@fcwilt said in sensor ir:

M98 P"config.g"

[fcwilt]

@sgk

Thank you.

It seems that the IR sensor is working based on the LEDs on it responding to the presence of the bed.

The M558 configuration seems to be correct and if it is in your config.g file it appears to be executing without any problems.

So that really seems to leave only the connection from the IR Sensor output to the Duet Z Probe input.

Do you have a meter of any sort that can verify continuity of the wire from the connector for the IR Sensor all the way to the connector for the Duet Z Probe input?

Frederick

[A Former User]

@fcwilt yes I tested with a multimeter the continuity

[fcwilt]

@sgk said in sensor ir:

@fcwilt yes I tested with a multimeter the continuity

OK can you do this:

• Disconnect the connector from the IR Sensor
• Using a small piece of wire or equivalent connect the signal and ground pins of that connector and check the DWC Z probe reading
• Then do the same but connecting the signal and power pins

Frederick

[jumpedwithbothfeet]

@sgk I just looked at your config.g what firmware version are you using version 1? it might be an idea to update it!

[A Former User]

@fcwilt
you can tell me what they are

[A Former User]

@jumpedwithbothfeet no

[fcwilt]

@sgk said in sensor ir:

@fcwilt
you can tell me what they are

Sorry but I don't understand what you mean.

Frederick

[A Former User]

@fcwilt sorry which thread

[fcwilt]

@sgk said in sensor ir:

@fcwilt sorry which thread

You said "you can tell me what they are".

I don't know what you mean by that.

Frederick

[A Former User]

@fcwilt sorry my translator is kidding

[fcwilt]

@sgk said in sensor ir:

@fcwilt sorry my translator is kidding

OK I will post again my question again:

OK can you do this:
- Disconnect the connector from the IR Sensor
- Using a small piece of wire or equivalent connect the signal and ground pins of that connector and check the DWC Z probe reading
- Then do the same but connecting the signal and power pins

Frederick

[A Former User]

the probe works but when I do g30 s-1 the bed stays at a great distance from the nozzle as in the photo

[A Former User]

[fcwilt]

@sgk

If you move the bed away from the probe, say to Z=5, does then doing a G30 or a G30 S-1 result in the bed moving and triggering the probe?

Frederick

[A Former User]

@fcwilt yes

[A Former User]

@fcwilt

[A Former User]

the bed remains loing of the nozzle

[A Former User]

This post is deleted!