Unable to find in Device Manager
-
Amazing thanks alot!!! I am helping my husband ( i am more technical than him) but still not that technical! Will keep trying to set it up!
-
I didnt get far, i installed YAT and its looking for port (COM port) but there is nothing there and there is nothing in device manager. I am connected to the Panel but via USB am i doing something wrong?
-
@darbyad85 what is it that you have connected to the PC: the Duet, or the PanelDuet? You should connect the Duet's USB port to the PC.
-
Thanks for your quick reply - so i am not sure the difference between the Duet and the PanelDuet - currently my laptop is connected to my WIFI and a USB connection to the small 7 inch panel but the 4 pin cable that goes into the big machine is not plugged in - does that need to be plugged in ?
Thanks again -
The Duet is the electronics board that controls the printer. The PanelDue is the touch screen interface for it.
Here are the instructions for updating the firmware on the Duet: https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_firmware
Here are the instructions for updating the firmware on the PanelDue:
https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_PanelDueAnd here are the instructions for "getting started" I suggest you start here: https://docs.duet3d.com/en/How_to_guides/Getting_connected/Getting_connected_to_your_Duet
-
@darbyad85 said in Unable to find in Device Manager:
does that need to be plugged in ?
It will need to be in order to use it, yes, but not to update it.
https://docs.duet3d.com/en/User_manual/Connecting_hardware/Display_PanelDue
-
@phaedrux thank you.
so where I am is that the DuetDue touchscreen panel firmware has been updated, it says 'connecting' in the top right corner.As for my laptop I still can't find the Duet in device manager and now I've downloaded YAT I can't select it as a serial port.
Not sure where to go from here... can the panel really be faulty? It was brand new out of the box.
-
@darbyad85 the "Connecting" message on the PanelDue means that it is trying to connect to a Duet or other 3D printer control board via a serial link, not to the PC. Is the PaneDue connected to a 3D printer control board, and if so, what sort?
-
@phaedrux said in Unable to find in Device Manager:
And here are the instructions for "getting started" I suggest you start here: https://docs.duet3d.com/en/How_to_guides/Getting_connected/Getting_connected_to_your_Duet
If you follow along with this, how far do you get?
-
@phaedrux I am as far as connecting to WIFI and im blocked again
I have started another thread asking for help
