LIS3DSH placement

tecno

470pF or even 1nF

Sorry NoGo

tecno

Just made a very short cable just to verify if port on Duet board is busted or not = it is not.

So the long cable I have is just too much ~2.10m, Maybe I can cut it down to ~1.6m, need to have space to move all axis for input shaping.

tecno

Did cut down the cable = NoGo

tecno

Is it really that bad that my accelerometer boards are useless due to cable lenght?

Is there any development as regards Smart effector to include accelerometer?

dc42

@tecno I am pushing for the combined Smart Effector and tool board to be done soon. We will increase the size and the rod spacing (perhaps from 55 to 70mm) to accommodate a small direct drive extruder, and maybe change the hot end mounting to suit the E3D Revo Voron hot end. Does that sound OK?

tecno

@dc42
That sounds to be very good solution to get all signals as short as possible.

If you need a beta tester I am here awaiting

achrn

@dc42 said in LIS3DSH placement:

@tecno I am pushing for the combined Smart Effector and tool board to be done soon. We will increase the size and the rod spacing (perhaps from 55 to 70mm) to accommodate a small direct drive extruder, and maybe change the hot end mounting to suit the E3D Revo Voron hot end. Does that sound OK?

FWIW, it sounds fabulous to me - it has been mentioned a number of times, and I expect I'll place an order as soon as I see it (I'd even pre-order). Personally, I'd prefer a Revo Micro (because I currently have a revo micro on my smarteffector, so it avoids additional purchases) but I'd still buy if I needed a new Revo heatsink.

My preferred extruder would be orbiter (which I have on other printer and am happy with), but I do note that it's more eccentric (about the filament path) than some other options.

tecno

@achrn
I run a watercooled Phaetus Dragon with Orbiter V2.0 so it only needs a new SE board.

apak

@dc42 awesome.....can´t wait for it!!!

janjoh

@dc42 said in LIS3DSH placement:

E3D Revo Voron

Remind me, is that one "bolt compatible" with the Mosquito from Slice Engineering? If it is; Sign me up for a pre-order!