Software bundle 3.5.0rc.4 now available
-
@CrazyCreator looks like a cloned board. best ask Fysetc...
-
@jay_s_uk The board came with the printer... No idea if it's a clone or not. But the clones are also made according to the specifications, aren't they?
-
@CrazyCreator well its black, so its a clone.
And I know some Fysetc "clones" don't 100% match duet boards -
@jay_s_uk
What kind of rubbish is that?
Well then I'll try to bridge the two pins.
If the board wears out, then at least an original one comes in
btw
Here is a picture of a board from Filafarm (official seller in Germany), there is no erase jumper at this position. However, that is a 0.6 board in the picture.
-
Here is a picture of a board from Filafarm (official seller in Germany), there is no erase jumper at this position. However, that is a 0.6 board in the picture.
Here you are:
-
I know... I saw that.
I just wanted to show that there are also duet boards where the jumper is in a different place. So it's quite possible that this is the case on my board too. -
@CrazyCreator clones are based on the v1, not the 0.6
-
@jay_s_uk
But ... My Erase Button is on Position from v0.6 and on the Board itself is writing v1.01 ... it's a little bit funnny -
3.5 is now released
-
undefined Phaedrux locked this topic
-
@CrazyCreator said in Software bundle 3.5.0rc.4 now available:
But ... My Erase Button is on Position from v0.6 and on the Board itself is writing v1.01 ... it's a little bit funnny
Yup, it’s stuff like that that means we don’t support clones. And they don’t pay us to. Or make it easy for their customers to get support.
Ian
