Ethernet not working what did i miss ?

[the_lund]

Okey i have copy the sd card form the old one with that result that the ip is 0.0.0.0.

network is enable. but still no light

[the_lund]

i have not switch the sd cards around butt still only the old is working

[the_lund]

i did the set up 8 times now still no light

Maby it is just a bad board

[T3P3Tony]

@the_lund strange that the Ethernet LEDs do not light up, but it got an IP address what happens if you ping it:

ping 192.168.0.22

You say you have a Duet Ethernet that is working, what happens if you unplug the ethernet cable from that and plug it into the new one, with only 5V power applied and nothing else plugged in?

[the_lund]

Did not work sorry ping the wrong ip
i have tryed with the cabels

[T3P3Tony]

@the_lund what is displayed in the browser when you go to the IP address?

[the_lund]

@t3p3tony

Did not work sorry ping the wrong ip

Another pc has taken the same ip

i have tryed with the cabels

[the_lund]

i get to a site like when your net broke down

[T3P3Tony]

@the_lund it sounds like the board is faulty, please would you contact the reseller you bought it from and arrange a replacement under warranty.

[the_lund]

@t3p3tony i will i bought it direct from http://duet3d.com

Thanks for your help

[cabal2000]

I am having a similar issue. With USB cable connected the ethernet stays on but the minute I disconnect the USB and power up the board, it stays on for a few seconds and then turns off.

[dc42]

@cabal2000 said in Ethernet not working what did i miss ?:

I am having a similar issue. With USB cable connected the ethernet stays on but the minute I disconnect the USB and power up the board, it stays on for a few seconds and then turns off.

Do you mean that just the Ethernet turns off, or something else?

Do you have a jumper on the I_5V_EN pins, to enable the internal 5V regulator?

[cabal2000]

@dc42 Ethernet shuts off. Blinks for a few seconds and stops.

[dc42]

Do the red 5V and green 3.3V LEDs on the Duet go off as well?