Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tags
    3. firmware upgrade
    Log in to post
    • All categories
    • crispusundefined

      Updating Duet3 Firmware via apt

      Firmware installation
      • firmware upgrade duet 3 raspberry pi • • crispus
      4
      0
      Votes
      4
      Posts
      300
      Views

      crispusundefined

      @jay_s_uk @Phaedrux - Thanks for taking time to reply. I followed the process using BOSSA and it seems to have worked.

      FIRMWARE_NAME: RepRapFirmware for Duet 3 MB6HC FIRMWARE_VERSION: 3.1.1 ELECTRONICS: Duet 3 MB6HC v1.01 or later FIRMWARE_DATE: 2020-05-19b2

      Cheers,

      Christian

    • jseraundefined

      Duet 2 wifi restart at firmware install

      Firmware installation
      • firmware upgrade • • jsera
      4
      0
      Votes
      4
      Posts
      266
      Views

      jseraundefined

      Awesome, thank you, got it updated. Appreciate the detailed writeup. A suggestion is I'd put that info with the other disclaimers under "Usual procedure" because I didn't read that far down, figured that didn't apply to me. Thanks though. Looking fwd to using these boards!

    • blarblesundefined

      Duet 3 - install firmware reset

      Firmware installation
      • duet 3 raspberry pi firmware upgrade • • blarbles
      2
      1
      Votes
      2
      Posts
      393
      Views

      dc42undefined

      The 3.0 beta firmware had a problem with frequent data corruption when you uploaded files using the on-board Ethernet. Maybe that was the reason?

    • TLASundefined

      8-Factor Delta Calibration Upgrade (print centering issues)?

      Tuning and tweaking
      • firmware upgrade monte-carlo 8-factor woes • • TLAS
      3
      0
      Votes
      3
      Posts
      278
      Views

      TLASundefined

      @Dougal1957 said in 8-Factor Delta Calibration Upgrade (print centering issues)?:

      I am not certain but I believe the tilt adjustments the firmware makes is to the tower tilts NOT THE BED DC will have to confirm this mind.

      FYI: From the calibration page:

      Bed should be at right angles to the towers in both X and Y directions
      Actually, this isn't essential, because RepRapFirmware can compensate for bed tilt. Unfortunately, auto calibration can't easily distinguish between bed tilt and differences in tower separation. One approach to getting the bed level is to mount it on 3 equal-length spacers attached to the lower horizontal frame. If you are using metal corners, the horizontal frame should be at right angles to the towers. If you do need to make any adjustment, you can stack washers or shims on top of one or two of the spacers.