@Veti Oh I see, yes its supposed to be 3950. Thanks again!

@Veti thanks for the tip. What makes your think they are wrong? Is that a standard number that needs to be changed? Or is it the format its written in?

@Phaedrux Ok thanks for the info, appreciate it.

config.g

See attached. Thanks

Hi guys,

I just retrofited my CR-10 with a duet 2 wifi, going great so far! The only thing I noticed is that prints take 150% longer than what simplify 3d estimates. I used the same profile as my CR10 for slicing for this duet retrofit so I dont think it's slicer related. I dont think its speed related either. I do notice the extruder pauses for .5-1s between steps, when retracting filament. What setting should I look at to speed that up? Like I said,my CR-10 didnt do this and Im using the same slicing profile so it's strange...

So the cables were very close (y stepper and bed thermister). I separated them and shielded the stepper and now its a straight curve. No fluctuation anymore. Thanks for the help!

Thanks for the tips guys, yes its right under a stepper and the more I notice, it fluctuates more when that axis moves. I havent seen what kind it is, but it has 2 white wires so Im thinking its the same as the hot end, 100k thermister.

Hi guys,

I just retrofitted my Creality CR10 Pro with a duet 2 wifi and Im seeing very high fluctuation of my bed temp (using bang bang method). This only starts about an 30mins after starting a print and when I pause printing the line straightens out. Paused, I also wiggle some cables to see if it fluctuates but it doesnt seem to. Any ideas what the issue might be?

Awesome, thank you, got it updated. Appreciate the detailed writeup. A suggestion is I'd put that info with the other disclaimers under "Usual procedure" because I didn't read that far down, figured that didn't apply to me. Thanks though. Looking fwd to using these boards!

Hi guys,

Im trying to update my firmware from 2.05 to the latest(3.something) and on wifi when I go to install, it says communication lost and when I do it with usb, right after I issue the install firmware command I hear the usb disconnect and connect sound, get no feedback and when I check if I have the latest firmware, it still says the older one.

Any idea what the issue could be?