Z-probe triggers way above table during HOME ALL
-
@dc42 went through the same set up process as described in test and calibrate Z probe, same results as before, it moves down 10 mm then triggers then stops. I did nottice, as it is moving towards the X-Y home position, the IR sensor flashes 3 times like it is just initialized. Never done that before either.
www.dpp3d.com , pellet fed large format 3d printers
-
@phaedrux went through the same set up process as described in test and calibrate Z probe, same results as before, it moves down 10 mm then triggers then stops. I did nottice, as it is moving towards the X-Y home position, the IR sensor flashes 3 times like it is just initialized. Never done that before either.
-
Tried running a G29 and this is what I am getting back now. I have never had this kind of issue with my duet3d before. its triggering during moves.
-
Is the sensor on the IR probe dirty or damaged at all?
-
@phaedrux No, i have even swapped it out with a new probe and it does the same thing!! I am baffled!!! to say the least. As you can see it won't run a G29 anymore either
-
@phaedrux I have another Duet3d wifi board, I am going to swap it out in the morning and reload my firmware and see if that does it
-
Can you post your config.g as it is now?
-
-
-
That all looks right to me.
Do you have anything weird in config-overide.g?
-
-
That all looks fine as well.
-
Firmware version?
Double check wiring? Bad crimp? Clean the sensor with some isopropyl?
-
-
@phaedrux do you have a link to the latest update?
-
-
@phaedrux thank you, I will update today and check for hardware issues
-
@billsrf said in Z-probe triggers way above table during HOME ALL:
@dc42 went through the same set up process as described in test and calibrate Z probe, same results as before, it moves down 10 mm then triggers then stops. I did nottice, as it is moving towards the X-Y home position, the IR sensor flashes 3 times like it is just initialized. Never done that before either.
Perhaps you have a bad crimp connection in the sensor cable, so that one of the 3 wires disconnects at certain XY positions?
