Soft reset procedure?

peirof

Hi,

After issues commented in another post... I dlike to do a soft reset of Duet....

I can't find the procedure for do a soft reset...

What are the steps? Exists a hard reset procedure?

Veti

the soft reset is the command M999
https://duet3d.dozuki.com/Wiki/Gcode#Section_M999_Restart

peirof

I have try soft reset.... Erase macros and gcode files.. But no, config.g....

And the same problem with fans...

I am searching a procedure for factory default

deckingman

@peirof I'm not exactly sure what you are looking for. As @veti has said, M999 will restart the firmware. If you want to re-run config.g you can send M98 P"config.g". Does that help?

T3P3Tony

@peirof the closed you get to a "factory default" config would be
https://github.com/T3P3/Duet/tree/master/Duet2/SD Card Contents
but those are just for testing.

I would either continue to work with your existing config, or generate a new one with the https://configtool.reprapfirmware.org

peirof

My intention was to test if the two of the fans did NOT work, and gave a voltage lower than 24v, was due to a configuration failure ... but it does not seem likely ...

What other options do I have?

Try a downgrade?

Veti

The duet fan voltage is either vin or 5v depending on how the jumper is set.
the duet uses a pwm signal on the negative to slow down the fans.

at 100% no pulsing is taking place

post your
M106
from your config.