Tuning Jerk/Accel/Speed settings

[Phaedrux]

@RyanP said in Tuning Jerk/Accel/Speed settings:

If you are tuning Jerk after travel acceleration, do you have a starting jerk value to use during the dry run print?

600mm/min (or 10mm/s) seems like a good floor.

[RyanP]

@Phaedrux said in Tuning Jerk/Accel/Speed settings:

@RyanP said in Tuning Jerk/Accel/Speed settings:

If you are tuning Jerk after travel acceleration, do you have a starting jerk value to use during the dry run print?

600mm/min (or 10mm/s) seems like a good floor.

Well, its good to know that my mind is in the right place. I was in my config.g file changing my M566 for X and Y to 600, and as I hit save, I got the notification of your reply.

Much appreciated for the confirmation of my own thoughts. Youre the best.

[Phaedrux]

@RyanP I figure 10mm/s is a pretty slow print speed. You don't want it to slow down too much at corners because that causes its own issues.