Need Probe Setup Help

jay_s_uk

If you send M558, what does it output?

1d1

M558
Error: M558: Z probe 0 not found

jay_s_uk

I've just realised why. You've used a duet 3 pin name with a duet 2.
Where do you have it connected?

1d1

At position E0 on the endstop connectors

jay_s_uk

change your command to

M558 P8 C"!e0stop" H5 F300 T6000 R0.4

1d1

@jay_s_uk said in Need Probe Setup Help:

M558 P8 C"!e0stop" H5 F300 T6000 R0.4

Done.

1d1

Before you ask:

m558
Z Probe 0: type 8, input pin !e0stop, output pin nil, dive height 5.0mm, probe speed 300mm/min, travel speed 6000mm/min, recovery time 0.44 sec, heaters normal, max taps 1, max diff 0.03

jay_s_uk

Run G30 and see if it probes.
I would make sure you've homed your machine using G28 and then tap the probe on the way down to make sure it stops

1d1

@jay_s_uk
"Probe already triggered"

Remove exclamation point from 558?

jay_s_uk

yes please

1d1

Great progress! G30 starts probe quite slowly, stops immediately when triggered and raises up a bit.
Do it again with probe?

jay_s_uk

now you've got the height set you can G32 (assuming your bed file is correct)

1d1

Sorry - took a bit of doing, but G32 yields a 6 point probe. You are awesome. Now, M500?

jay_s_uk

@1d1 yep.

1d1

Excellent. Can I buy you a beer? Your time and effort is much appreciated.

jay_s_uk

No need. I prefer to see people being able to print

1d1

Well, great! Many thanks.

Interested in one more area I need some help with? Regarding Fan pins and activation...

1d1

Never mind - I actually found the problem on my own. Hard to believe.... !

Thanks again...