Duet3D Logo

    Duet3D
    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Laser filament monitor/filament present switch

    Duet Hardware and wiring
    2
    3
    65
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • mendelevium
      mendelevium last edited by

      I am about to fit the laser type filament monitors. My extruders are designed with a built in microswitch for detecting filament present. According to the instructions, the terminals are normally closed when the filament is present. Can someone link me to a wireing diagram of a laser filament monitor (1.7) incorporating the filament present microswitch?
      Some links to configuration appreciated. I have two extruders with two seperate hotends in my setup.
      Many thanks in advance...

      alankilian 1 Reply Last reply Reply Quote 0
      • alankilian
        alankilian @mendelevium last edited by alankilian

        @mendelevium

        THIS page says to connect your "Filament-out" microswitch to the "SW" pins on the LASER filament monitor PCB.

        THIS page says then choose monitor type 6 "P6"

        SeemeCNC Rostock Max V3 converted to V3.2 with a Duet2 Ethernet Firmware 3.2 and SE300

        mendelevium 1 Reply Last reply Reply Quote 1
        • mendelevium
          mendelevium @alankilian last edited by

          @alankilian
          So the switch is just connected to the pcb. Thought otherwise. Thanks for your link says all.. been trying to lookup all this. Thanks again.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA