M500 after PID autotune overwrites G31 in config-override.g

[flobler]

@fcwilt That's a great point, thank you!

[dc42]

@phaedrux said in M500 after PID autotune overwrites G31 in config-override.g:

Will have to check with DC42 on whether this is the expected behaviour of M500.

What should be happening is:

• Once you save using M500 P31 then assuming you have one or more Z probes defined, a G31 line or lines will be written to config-override.g
• If you have M501 in config.g then that G31 command will be read at boot time and the "save G31 settings with M500 automatically" flag will be set. So subsequently, sending M500 without the P31 parameter will include saving G31 settings.
• If you delete config-override.g or you manually edit out the G31 lines from config-override.g and then reboot, M500 will no longer write the G31 settings unless you specify the P31 parameter.

[CR3D]

@dc42

see my post here:

https://forum.duet3d.com/topic/24830/config-override-parameters-gets-lost-after-saving/4

Looks like the same issue

[dc42]

@cr3d this is now fixed in the 3.4 source code.

[CR3D]

@dc42 ok perfect

When will it be released... we have to pack an idex machine on the weekend and that should also be included ...

[dc42]

@cr3d I can provide an internal build for you to test with. Would that help? Which Duet do you have?

[CR3D]

@dc42 Ok ... better than nothing

At this printer there is a Duet 2 Wifi EA + Duex 5

[dc42]

@cr3d the current internal build is at https://www.dropbox.com/sh/qkexrvhgsebbz0g/AAD9gfyS8UIU5Sau311WS1oLa?dl=0.

[CR3D]

@dc42

Quick answer -> now it works!

We can use M500 / M500 P10 / M500 P31 / M500 P10:31 and nothing gets deleted

Thank you!

[flobler]

Great, thanks everyone for the help! Looking forward to the fix!