Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Industrial AC servo drive compatibility?

    Scheduled Pinned Locked Moved Solved
    General Discussion
    3
    5
    226
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Luka_Damundefined
      Luka_Dam
      last edited by

      Hello I am trying to use a Duet 3 MB6HC with a E1XD to control a servo driver with the step/dir signals of the E1XD.
      The problem is that the step and dir pins of the E1XD are 5V while the step and dir inputs of the driver are 12-24V, my question is if there is any way to use higher signal voltages on the expansion board.
      The driver that I'm trying to control is a Hiwin ED1S-VN-0422-A1.
      https://www.hiwin.de/en/Products/Servo-drives/Servo-drive-ED1/Servo-drive-ED1S-VN-0422-A1/p/23.00097
      Thanks.

      mrehorstdmdundefined Falkiaundefined 2 Replies Last reply Reply Quote 0
      • mrehorstdmdundefined
        mrehorstdmd @Luka_Dam
        last edited by

        @luka_dam something like this might do the job: https://www.petervis.com/electronics guides/frequency multiplier 2/5v to 12v conversion.html

        https://drmrehorst.blogspot.com/

        1 Reply Last reply Reply Quote 0
        • Falkiaundefined
          Falkia @Luka_Dam
          last edited by Falkia

          @luka_dam made a quick check in the manual and it looks like positioning mode type 6 supports TTL levels.

          Screenshot_20211214-203003_1.png

          Printer: "Deltacus" Delta with 510mm bed diameter and 925mm build height. Powered by Duet 2 WiFi. Duet Smart Effector with E3D Volcano.

          Luka_Damundefined 1 Reply Last reply Reply Quote 1
          • Luka_Damundefined
            Luka_Dam @Falkia
            last edited by

            @falkia thank you! I guess I missed it when I was looking in the manual.

            Falkiaundefined 1 Reply Last reply Reply Quote 0
            • Falkiaundefined
              Falkia @Luka_Dam
              last edited by

              @luka_dam You are welcome. Please mark this topic as "Solved".

              Printer: "Deltacus" Delta with 510mm bed diameter and 925mm build height. Powered by Duet 2 WiFi. Duet Smart Effector with E3D Volcano.

              1 Reply Last reply Reply Quote 1
              • Luka_Damundefined Luka_Dam has marked this topic as solved
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA