Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Weird error message when calibrating nozzle heater....

    Scheduled Pinned Locked Moved
    General Discussion
    3
    5
    163
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • peirofundefined
      peirof
      last edited by

      hi,

      i have try to tunning nozzle heater temperature control.

      With this gcode

      M303 H1 S240

      and.... this error

      21/2/2022 10:38:35	Error: Heater 0 fault: monitor 0 was triggered
      21/2/2022 10:38:32	Auto tune starting phase 2, settling
      21/2/2022 10:37:17	Auto tune starting phase 1, heating up
      21/2/2022 10:37:12	M303 H1 S240
      Auto tuning heater 1 using target temperature 240.0°C and PWM 1.00 - do not leave printer unattended
      

      this bug is new. Implying?

      gloomyandyundefined 1 Reply Last reply Reply Quote 0
      • Phaedruxundefined
        Phaedrux Moderator
        last edited by

        What firmware version?

        For tuning the hotend, try using M303 T0 S240 instead to try tuning as a tool instead of just a heater. This will use the fan to try and compensate for it's cooling effect.

        Z-Bot CoreXY Build | Thingiverse Profile

        peirofundefined 1 Reply Last reply Reply Quote 0
        • gloomyandyundefined
          gloomyandy @peirof
          last edited by

          @peirof When you ran this test did you also have the bed heater turned on?

          peirofundefined 1 Reply Last reply Reply Quote 0
          • peirofundefined
            peirof @gloomyandy
            last edited by

            @gloomyandy no...

            1 Reply Last reply Reply Quote 0
            • peirofundefined
              peirof @Phaedrux
              last edited by

              @phaedrux said in Weird error message when calibrating nozzle heater....:

              M303 T0 S240

              I have tried that gcode (M303 T0 S240), and the same error. But the Hotend fan does not turn... I thought that the fan was not working... but on the Status page, I made it turn manually... I am going to check if I have the temperature sensor configured correctly, maybe it's reading another temperature than the real one...

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA