WiFi disconnect errors

dc42 · 23 Dec 2017, 08:18

There is something about the wifi module starting up when the firmware has just been changed from the old SDK to the new one, which seems to take a few resets to sort out.

KeeganB · 23 Dec 2017, 18:30

Ok, thats good to hear. As a positive update, it has stayed connected with NO ISSUES since I manually started the module up. I also changed the channels on the router from what they were (neither were channel 1, or others that i have seen reported as possibly problematic).

Everything seems to be going well right now. I will continue testing.

SputnikOC3d · 4 Apr 2018, 15:00

this looks like the general thread for wifi disconnection issues … How do i get the wifi module on my board to turn back on ... and what causes it to shut down?

Im mid print - it disconnected and wont connect now - waking up to an over nite print with a couple more hrs to go and no connectivity - No PanelDue

FBG · 4 Apr 2018, 16:57

Today i am having the same problems, WIFI disconnection… I must reload page a lot times until the wifi conect.
Somebody with the same problem?
I have 1.21 version

dc42 · 4 Apr 2018, 19:49

@SputnikOC3d:

this looks like the general thread for wifi disconnection issues … How do i get the wifi module on my board to turn back on ... and what causes it to shut down?

Im mid print - it disconnected and wont connect now - waking up to an over nite print with a couple more hrs to go and no connectivity - No PanelDue

I just replied to a similar question (yours?) in another thread.

dc42 · 4 Apr 2018, 19:50

@FBG:

Today i am having the same problems, WIFI disconnection… I must reload page a lot times until the wifi conect.
Somebody with the same problem?
I have 1.21 version

See https://duet3d.dozuki.com/Wiki/WiFi_disconnections_and_AJAX_timeout_errors if you haven't already.

FBG · 5 Apr 2018, 06:45

I think than my problem i this:
READ: WiFi signal strength -73dBm, reconnections 0, sleep mode modem

I will search the threat where you talk about the external antena, but i am worry if i broken doing this

dc42 · 5 Apr 2018, 11:28

I agree, you need a better signal strength. There is a section on improving wifi signal strength at the end of the wiki page on improving wifi signal strength. An extra WiFi repeater in the room where the printer is may be the simplest option, and a repeater only costs about £20-£25.

xepherys · 4 Aug 2018, 23:15

I've been running into disconnect errors since I started using a Duet several months back. I've upgraded it (the issue has persisted through versions) and am currently running:

Firmware Electronics: Duet WiFi 1.02 or later + DueX5
Firmware Version: 2.01(RTOS) (2018-07-26b2)
WiFi Server Version: 1.21
Web Interface Version: 1.21.2-dc42

My signal is good (-47dBm), have no issues with other devices disconnecting (save for one IoT device that is far away from my router and disconnects expectedly), and have perused the troubleshooting steps in the other thread. It seems to generally disconnect after running commands in the console from the PanelDue, though it happens from time to time without that. I've never seen it lose WiFi during a print, only when idle. Time doesn't appear to be a factor - sometimes it drops out after 5-10 minutes from a power up, sometimes it's good and online for a day or two at a time.

dc42 · 6 Aug 2018, 08:18

When it disconnects, are you able to reconnect DWC, or not?